Materials - 2003

Materials Provided to Each Syndicate
  • Four 4' x 8' x 1/4" pieces of plywood
  • Four 2" x 2" x 8' boards
  • Four 1" x 2" x 8' boards
  • One 2" x 4" x 8' board
  • One caulking gun
  • Sikaflex®-291 Sealant
  • Wire
  • Plastic Cable Ties

Sailboats Also Get

  • 50' of 1/4" polyester rope
  • One 5/16" drill bit
  • One 20' aluminum tube, 1" inside diameter, 1 1/4" outside diameter, .581 lbs./ft.
  • One roll of 30 yards x 2" duct tape

Each Syndicate May Bring the Following
      • Tape Measure
      • Pliers
      • Cordless Drill
      • Sawhorses
      • Additional Cable Ties
      • Clamps
      • Sabre Saw

Note:

  • No table saws or similar workshop tools will be permitted.
  • Absolutely no power tools other than those specified are allowed.
  • No nails are allowed.
  • All boats must be bonded using Sikaflex®-291 Sealant.
  • Clamps, wires, or cable ties may be used to hold boat together while Sikaflex®-291 Sealant is curing, but they must be removed or cut prior to seaworthiness trials.